Security Link SL150 Guide de l'utilisateur télécharger pdf (Page 33)

- 33 -

Testing the System (cont'd)

The display will clear when no motion is

detected. Note that if you are using wireless

motion detectors, there is a 3-minute delay

between activations. This is to conserve battery

life.

To test all smoke detectors, follow the

manufacturer's instructions. The keypad should

display the identification of each detector when

each is activated.

If you experience a problem with any protection

point (no confirming sounds, no display),

CALL

FOR SERVICE IMMEDIATELY.

When you have checked (and closed, where

necessary) all protection points, no zone

identification numbers should be displayed on

the keypad.

When you complete testing, exit the TEST

mode by continuing with step 5.

OFF

(Security Code)

Exit TEST mode.

Enter your security code and press the OFF

key.

If you inadvertently leave the test mode active,

it automatically turns off after approximately 4

hours

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 59 60

Pas de commentaire

Security Link SL150 Guide de l'utilisateur Page 33