Security Link SL150 Guide de l'utilisateur télécharger pdf (Page 36)

- 36 -

Trouble Conditions (cont'd)

POWER

indicator (if

present) is off.

LOSS

is displayed.

The system is operating on battery power only. If

only some lights are out on the premises, check

circuit breakers and fuses and reset or replace as

necessary.

CALL FOR SERVICE

if AC power

cannot be restored to the system.

Busy-Standby

(or

)

If this remains displayed for more than 1 minute,

system is disabled.

CALL SERVICE AT ONCE.

OPEN CIRCUIT

(or

)

The keypad is not receiving signals from the control.

CALL SERVICE AT ONCE

Long Rng Trbl

(or

)

If programmed, backup Long Range Radio

communication has failed.

CALL SERVICE AT

ONCE.

Bell failure

(or

CHECK 70

)

Bell/Siren supervision failure.

CALL SERVICE AT

ONCE

RF Jam

(or

Check 90

)

If enabled and a Receiver Jam is detected, a report

will be sent to the monitoring station and at the

same time a

Rcvr Jam

message will toggle with the

present display on the Alpha keypad. When the jam

condition is cleared, a Restore message is sent to the

monitoring station. To clear the keypad display,

enter your 4-digit code and press the OFF key.

In The Event Of Telephone Operational Problems

In the event of telephone operational problems, disconnect the control by removing the

plug from the RJ31X (CA38A in Canada) telephone wall jack. We recommend that

your certified installer demonstrate disconnecting the phones on installation of the

system. Do not disconnect the phone connection inside the control/communicator.

Doing so will result in the loss of your phone lines. If the regular phone works correctly

after the control/communicator

has been disconnected from the phone lines, the

control/communicator has a problem and should be returned for repair. If, upon

disconnection of the control/communicator, there is still a problem on the line, notify

the telephone company that they have a problem and request prompt repair service.

The user may not under any circumstances (in or out of warranty) attempt any service

or repairs to the system. It must be returned to the factory or an authorized service

agency for all repairs.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Security Link SL150 Guide de l'utilisateur Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Security Link SL150