Security Link SL150 Guide de l'utilisateur télécharger pdf (Page 37)

- 37 -

Fire Alarm System

(If Installed)

General Information

Your fire alarm system (if installed) is active 24 hours a day, providing

continuous protection. In the event of an emergency, the installed smoke and

heat detectors will automatically activate your security system, triggering a

loud, interrupted sound from the keypad. Optional exterior sounders will also

produce an interrupted sound. Your keypad will display a

FIRE

message (with

zone location) until you silence and clear the alarm display.

In Case of Fire

1. Should you become aware of a fire emergency

before

your detectors sense the

problem, go to your nearest keypad and press the panic key pair assigned as

FIRE emergency (if programmed by the installer). The alarm will sound.

2. Evacuate all occupants from the premises.

3. If flames and/or smoke are present, leave the premises and notify your local

fire department immediately.

4. If no flames or smoke are apparent, investigate the cause of the

alarm.

The

keypad will display the zone descriptor of the zone(s) in an alarm condition.

Silencing a Fire Alarm

Silence the alarm by pressing the

OFF

key.

To clear the alarm display, enter your security code and press the

OFF

key again.

2. If the keypad indicates a trouble condition after the second OFF sequence,

check smoke detectors to see if they are responding to smoke or heat-

producing objects in their vicinity. Should this be the case, eliminate the

source of heat or smoke.

3. If this does not remedy the problem, there may still be smoke in the

detector. Clear it by fanning the detector for about 30 seconds.

4. When the problem has been corrected, clear the display by entering your

code and pressing the

OFF

key.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 59 60

Pas de commentaire

Security Link SL150 Guide de l'utilisateur Page 37