Security Link SL150 Guide de dépannage télécharger pdf (Page 124)

SL150 Installation and Setup Guide

25–2

(including Wireless - cont'd)

SYMPTOM

POSSIBLE CAUSE REMEDY

5b. If no response at all from this

transmitter, this physical transmitter

has not been enrolled by the system.

Transmitter Sniffer display is being

cleared by another unit programmed for

this zone.

5b. Determine which transmitter is

programmed for this zone and reprogram

as necessary.

6. Nuisance or phantom

alarm.

6a. Sensors not properly installed, wired, or

monitored.

6a. Check installation to see if in accordance

with established procedure.

6b. Universal transmitter (5817) programmed

wrong.

6b. Check programming switches on

transmitter.

7. Intrusion alarm for no

apparent reason.

7a. Protected door or window opened while

system armed.

7a. Check with all occupants of protected

home.

7b. Improper user operation of exit/entry

delays.

7b. Check setting of entry and exit delays.

7c.

Magnets

located too far from switches,

and/or doors and windows not properly

aligned.

7c. Check all openings for proper switch and

magnet orientation.

8. “CHECK” and zone number

2–8 are displayed.

8. Control has sensed a high resistance

condition on a loop in one of the

hardwired zones (2–8).

8. Check the sensor or the loop wiring in the

affected zone. The system will not arm

until this condition is corrected (or the

affected zone is bypassed).

SYMPTOM POSSIBLE

CAUSE REMEDY

1. AC POWER light off.

1a. Interrupted AC power supply. 1a. Check transformer connection and

power line circuit breaker.

2. Digital communicator

message not being received.

2a.

SL150

in Test mode.

2b. Telephone connection not secure.

2c. Digital communicator malfunctioning.

2d. Telephone number in program needs

prefix or access code.

2e. Telephone call to central monitoring

station requires operator assistance.

2a. Remove from Test mode.

2b. Check all connections.

2c. Check with a different

SL150

2d. Program prefix or access code into the

SL150

2e.

SL150

system cannot work in this

situation.

3. Does not arm properly.

3a.

READY

light not on. 3a. Check for faulted zones and make

intact, or use Bypass arming, if desired.

SL150

doesn't respond to

keystrokes on keypad.

4a.

MODEM COMM

displayed:

System is in communication with

downloader at Central Station.

4b.

SYSTEM BUSY

displayed: System

has just been powered and is in its 1-

minute initialization.

4c.

displayed: More zones have been

programmed than the zone Expansion

Modules can handle.

4d. Keypad address setting incorrect.

4a. Wait until download session is finished.

4b. To bypass this time, press '#' + '0'.

4c. Delete some zones or use a higher

capability RF receiver.

4d. Keypads must be set for address 31

(non-addressable mode).

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 143 144

Commentaires sur ces manuels

Pas de commentaire

Security Link SL150 Guide de dépannage Page 124

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Security Link SL150