Security Link SL150 Guide de dépannage télécharger pdf (Page 87)

Section 16 -Zone Programming

16–5

ZT RC IN: L

10 – – – : –

ZT RC IN: L

10 00 10 RF:

If HW (hardwired) or AW

(Auxiliary) is entered for Input

Device Type, the next screen

will be similar to the above,

except that HW or AW will be

displayed under “IN”.

If RF, BR, or UR is entered, a

prompt for Serial and Loop

number will be displayed, as

below.

↓

10 INPUT S/N: L

AXXX-XXXX 1

10 INPUT S/N: L

A022-4064

To Delete a Serial

Number

→

Enter the first digit of the zone number to be programmed. In

the example at the left where zone 10 is to be programmed, the

first digit 1 is entered, followed by the 2nd digit 0. The display will

show dashes, as shown at left. If zone 8 was to be programmed,

you would press the 0 key, then the 8 key. You must always

program zones using two digits.

Use the [D] key to enter wireless keys. When the [D] key is

pressed, a special prompt will be displayed which offers a series of

default templates for wireless keys. Go to the paragraph on a

subsequent page titled Entering and Duplicating Wireless

Keys for the necessary procedure.

A display with that zone’s current programming will appear.

Press [

✱] to continue.

Enter Zone Type (ZN), Report Code (RC), and Input Device

Type (IN)* sequentially, but not the Loop No. (L).

Use the [A] (Advance) and [B] (Back) keys on the keypad to move

the cursor within the screen.

Use the [C] key to copy the previous zones attributes.

Press [

✱

] if the existing information is acceptable. If not, you can

press the [

] key to back up without saving.

Manually enter the serial number (found on the transmitter

label), by typing digits in the “X” locations, using the [A] (advance)

or [B] (back) keys as required. You can also perform two open and

close sequences; for button-type transmitters that means pressing

and releasing the button twice.

Note:

If you want to copy the previous zone’s serial number, press

the [C] key.

Press [

✱

] to advance to the loop number, then enter loop number.

Press [

✱] To accept the existing serial and loop number. If

necessary, press [#] to back up and re-enter or edit the serial

number before pressing [

✱] to save.

To delete an existing serial number, enter 0 in the loop number

field. The serial number will change to all 0's as shown.

10 INPUT S/N:

A000-0000 0

If 0 was entered in error, simply re-enter the loop number, and the

serial number will return to the display.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 143 144

Commentaires sur ces manuels

Pas de commentaire

Security Link SL150 Guide de dépannage Page 87

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Security Link SL150