Security Link SL150 Guide de dépannage télécharger pdf (Page 94)

SL150 Installation and Setup Guide

17–2

2. Zone List (ZL) is a group of zones to which the event applies in order to

activate a particular device. Note that there are 3 output device-related

zone lists that can be programmed in

✱

81 Menu mode; when the selected

event (alarm, fault or trouble) occurs in any zone in the selected

Start

zone list (1, 2, or 3), activation of the selected device will

Start

Start by Zone Type or System Operation

1. If a System Operation, such as disarming or

any

fire alarm

is to

activate the device, the appropriate choice would also be entered under

the ZONE

TYPE option. ZONE TYPE is used independently of the

“EVENT/ZONE LIST” combination.

If a ZONE TYPE is chosen, any zone of that response type going into

alarm, trouble, or fault will cause the device to activate as selected in

“ACTION.” If the same ZONE TYPE is also chosen for the Stop

programming, any zone of that type that restores will deactivate the

device.

If a

System Operation

is chosen (for example, end of exit time), that

operation will cause the device to activate as selected in action. The

different choices for ZONE TYPE and

System Operation

are listed in

“Programming Output Relays and Powerline Carrier Devices” later in this

section, and in the Programming Form.

STOP (STP):

The

Stop

programming determines when and under what conditions the

device will be deactivated. The following options are available:

Upon Restore of a Zone List

1. Restore Zone List (ZL): If a ZONE LIST is used as the Stop event, the

device will deactivate when all the zones in that list restore from a

previous fault, trouble, or alarm condition. This will occur regardless of

what is programmed to

Start

the device; therefore, a "RESTORE ZONE

LIST" would normally only be used when a ZONE LIST is used to

Start

the device.

Upon a Zone Type or System Operation

1. Zone Type/System Operation: Instead of using a "RESTORE ZONE

LIST", a specific zone (response) type or system operation action can be

selected to deactivate the device.

If a specific ZONE TYPE is chosen, any zone of that response type that

restores from a previous alarm, trouble, or fault condition will cause the

device to deactivate.

If a

System Operation

is chosen, that operation will cause the device to

deactivate. The different choices for ZONE TYPE and

System

Operation

are listed in “Programming Output Relays and Powerline

Carrier Devices” later in this section, and in the Programming Form.

During normal system operation,

you may start any devices manually by a keypad entry of:

Code + # + 7 + n

or stop them manually by a keypad entry of:

Code + # + 8 + n,

where n = the

device number to be controlled.

As a minimum, the ACTION (A) field must be programmed for this manual action to be operative.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 143 144

Commentaires sur ces manuels

Pas de commentaire

Security Link SL150 Guide de dépannage Page 94

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Security Link SL150