Security Link SL150 Guide de dépannage télécharger pdf (Page 63)

Section 13 - Mechanics Of Programming

13–3

Loading Factory Defaults

The control panel is shipped from the factory loaded with its factory defaults. To reload the

factory defaults at any time, enter the Programming mode, press

✱

97, then exit the

Programming mode.

Do not press

✱

97 to load defaults if any programming has been done previously—data already

programmed into the system will be changed!

This includes the primary and secondary

subscriber account numbers (fields

✱

43 and

✱

44), which will be set to their factory defaults

also.

✱

96 resets all the subscriber account numbers and CSID in preparation for an initial

download.

Programming System Setup Fields

The following program fields must be programmed before doing any zone programming:

✱

22 RF SYSTEM

Enter

if 5881/5882 RF Receiver is being used; enter

if no receiver is being used.

Default is

(none).

✱

WIRED ZONE EXPANSION

Use this field to select the type of expansion unit being used, as follows:

0 = none; 1 = 4219; 2 = 4229; 3 = 4204. Default is

Exiting the Programming Mode

✱

99 allows re-entry into the Program mode using [Installer Code] + 8 0 0.

✱

98 prevents re-entry into the Programming mode using the Installer code.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 143 144

Pas de commentaire

Security Link SL150 Guide de dépannage Page 63