
SL150 Installation and Setup Guide
15–8
✱
60 TROUBLE REPORT CODE (See box on previous page)
1 | 0
This will be sent if a zone goes into trouble.
✱
61 BYPASS REPORT CODE (See box on previous page)
0 | 0
This will be sent when a zone is manually bypassed.
✱
62 AC LOSS REPORT CODE
0 | 0
See box on previous page. Reports with subscriber number. Timing of this
report is random with up to a 4-hour delay. If AC restores before the report
goes out, there is no “AC Restore” report.
✱
63 LOW BAT REPORT CODE
1 | 0
This will be sent when a low-battery condition exists in the system’s standby
battery. See box on previous page. Reports with subscriber number.
✱
64 TEST REPORT CODE
0 | 0
This is sent periodically to test that the communicator and phone lines are
operational (frequency of report is selected in field
✱
51).
See box on previous
page.
Reports with subscriber number.
✱
65 OPEN REPORT CODE
0
This is sent upon disarming of the system. See box on
previous page.
✱
66 ARM AWAY/STAY REPORT CODE
0 | 0
AWAY STAY
This option allows for independent programming of Away and Stay reports.
2nd digit of report is user number if expanded or 4+2 reporting is selected.
NOTE:
Open reports are not sent if the associated Closing report is not
enabled.
✱
67 RF XMTR LO BAT REPORT CODE (See box on previous page)
1 | 0
This is sent in the event that a wireless transmitter low-battery condition
exists.
✱
68 CANCEL REPORT CODE
(See box on previous page)
1 | 0
This is sent upon disarming of the system after the alarm condition was
reported
.
✱
✱
✱70 ALARM RESTORE REPORT CODE
(
1st digit)
1
This is sent when the zone that caused an alarm is restored to its non-faulted
condition.
✱
71 TROUBLE RESTORE REPORT CODE
1 | 0
See box on a previous page.
This is sent when a trouble in a zone is restored.
Commentaires sur ces manuels